DEFINITE TIME OVERCURRENT RELAY

THIS MODEL WAS DEVELOPED USING MATLAB 2022 b VERSION.
OLDER MATLAB VERSION MIGHT NOT COMPATIBLE TO RUN THIS MODEL.
CHANGE THE FAULT TYPE, FAULT TIME & FAULT RESISTANCE UNDER FAULT BLOCK.
TO CHANGE THE FAULT CURRENT, CHANGE THE FAULT RESISTANCE INSIDE THE FAULT BLOCK.
THE SWITCHING TIME OF FAULT MUST BE LOWER THAN THE SIMULATION TIME.
THE SIMULATION TIME MUST BE HIGHER THAN THE SWITHING TIME + TIME DELAY.
CHANGE THE PICKUP CURRENT AND TIME DELAY UNDER RELAY SUBSYSTEM.
THE RELAY WILL ONLY TRIP WHEN THE FAULT CURRENT EXCEED THE PICKUP CURRENT AND THE TIME DELAY HAS BEEN ELAPSED

61.6 KB